Joint Separation Tools There are 12 products.

The FSH, FSM-Series parallel wedge spreader offer controlled separation without bending or risk of slipping from the joint. These spreaders are ideally suited to flanged joint applications

• Maximum Operating Pressure: 700 bar
• Tip Clearance: 6 mm
• Maximum Spread: 80 mm
• Maximum Spread Force: 8-14 ton

WR-5, WR-15 and A-92 Spread Cylinders

• Capacity: 0,75 - 1,0 ton
• Maximum Operating Pressure: 700 bar
• Maximum Spread: 94 - 292 mm
• Tip Clearance: 12,8 - 35,0 mm
• Single-acting, spring return

Enerpac FS-Series pin-type hydraulic flange spreaders are lightweight and have an ergonomic design for ease of use

• Capacity: 5 - 10 ton
• Maximum Operating Pressure: 700 bar
• Spread: 70 - 216 mm

NC-Series single-acting hydraulic nut splitters are compact and have an ergonomic design, easy to use

• Hexagon Nut Range: 10 - 75 mm
• Maximum Operating Pressure: 700 bar
• Bolt Range: M6 - M48

Enerpac NS-Series hydraulic nut splitters are specially designed to suit standard ANSI B16.5 / BS1560 flanges

• Maximum Operating Pressure: 700 bar
• Bolt Range: M45 - M90
• Hexagon Nut Size: 70 - 130 mm

The entire range of NCB-series replacement chisels for Enerpac NC-Series nut splitters

• Splits hexagon nuts ranging from 10mm to 75mm diameter
• Cuts bolts ranging from M6 to M48 diameter
• Not to be used on square nuts

Single-acting hydraulic nut cutter and hand pump for splitting and removing a stuck nut.

• 10 to 20-ton cutting force
• Hexagon Nut Range (mm): 19 to 41
• Bolt Range (mm): M12 to M27
• Not to be used on square nuts

The FSH-Series parallel wedge spreader offer controlled separation without bending or risk of slipping from the joint. These spreaders are ideally suited to flanged joint applications

• Maximum Operating Pressure: 700 bar
• Tip Clearance: 6 mm
• Maximum Spread: 80 mm
• Maximum Spread Force: 14 ton

Flange Spreaders plus ATEX Certified

If the flange joint you are working on has a minimum access gap of 4.0mm then this range of SWi flange spreading wedges are suitable. If the flange joint you are working on has a minimum access gap of 2.0mm and is of a smaller diameter and lower pressure then the MG7TM spreading wedges are suitable.

Secure Grip Spreading

Secure grip spreaders are likely to be suitable, if the flange you are working on has no access gap between the flanges or if you are concerned about damaging the flange faces or the flange joint, or if the flange join has a spacer, wafer or butterfly valve positioned between the flanges.

The FC10TE Hydraulic flange pulling tool can be used on any flange with a bolt hole diameter of 22mm (7/8”) or greater, and can pull from a distance of 600mm down to 0 mm with a force of 10T (100kN) per tool.

Equalizer nut splitting tools are designed to meet the challenges of bolted pipe-line flange joints.