Enerpac (5)

ECH, ECM-Series low profile pull down clamps for unobstructed top face machining

• Force: 3,9 - 17,4 kN
• Stroke: 5,1 - 7,9 kN
• Pressure: 15 - 350 bar

EFBE-Series Electric Flat Bar Cutters enhance workplace safety by replacing unsafe cutting methods with a precise, controlled cutting solution. 

• Maximum Material Hardness: HRc 33
• Maximum Material Height x Width: 50 x 17mm / 70 x 15mm
• Voltage: 120 and 230 Volt 

Battery-powered, remote controlled, heavy-duty machine moving system for clean and even surfaces

• Capacity (Set with Dual Follower Skate): 100 - 300 - 500 kN
• Transport Speed (loaded): 8 m/min
• Power Source: 24 Volt Battery 

EP-series Posi Lock® mechanical pullers offer a more efficient pulling, as one man can do the job where manual pullers often require two operators

• Capacity: 2 - 40 ton
• Max. Reach: 101 - 355 mm
• Spread Range: 12 - 635 mm

Enerpac EPH-Series Posi Lock® hydraulic pullers have a patented ‘Safety Cage’ jaw retention system.

ER-series heavy duty caterroller load skates have a rugged and sturdy construction for long life

• Max. Carrying Capacity: 80 ton

The Enerpac Trolley System provides an alternative method with increased benefits over traditional skidding methods

• Capacity Per Trolley: 500 - 1000 kN
• Travel Speed (loaded): 25 - 50 m/hr
• Motor Power: 0,38 - 0,75 kW

The ETT-Series is your solution for rotating heavy loads during, before or after a lifting and skidding operation.

• Maximum Capacity: 200 - 400 ton
• Cylinder Capacity: 25 ton (222 kN)
• Maximum Operating Pressure: 700 bar

The Enerpac EVOP-Series (Pump-per-Point) synchronous lift system provides industry leading speed and accuracy for 700 bar lifting operations.

• Lifting Points per Pump: 1x cylinder/pump
• Reservoir Capacity: 40 - 150 litres
• Flow at Rated Pressure: 2,1 - 8,0 l/min
• Motor Size: 3,0 - 7,5 - 15 kW
• Maximum Operating Pressure: 700 bar

FF-Series mechanical flange face tool is small and portable enough to be a permanent addition to your equipment range.

• Pipe Flange Cutting Diameter Range: ø 25-305 mm / 1-12"
• Internal Pipe Mounting Range; ø 25-152 mm / 1-6"
• Cutting Resultant Roughness; Ra 3,2 - 12,5 μ

FN, MF, BS-Series cylinder accessories are provided so that you can effectively position, mount and actuate Enerpac hydraulic cylinders according to your specific fixturing or production applications

The FSH, FSM-Series parallel wedge spreader offer controlled separation without bending or risk of slipping from the joint. These spreaders are ideally suited to flanged joint applications

• Maximum Operating Pressure: 700 bar
• Tip Clearance: 6 mm
• Maximum Spread: 80 mm
• Maximum Spread Force: 8-14 ton