Home

The CV5 incorporates a sequence valve which allows fast forward movement of a cylinder

This filter provides protection for NG6 block systems up to 200 bar

• P_IN: 20 - 207 bar (inlet pressure)
• P_H: 800 bar maximum (outlet pressure)
• P_RETURN: As low as possible (Return pressure to tank)
• Intensification ratios: P_H = (P_IN - P_Return) i (Intensification)
• Drain connections: Max. 10 bar
• Mounting: Inline tube

HC4W: 9 different intensification factors

• P_IN: Inlet pressure 20-207 bar
• P_H: 800 bar maximum (outlet pressure)
• P_RETURN: As low as possible (Return pressure to tank)
• Intensification ratios: P_H = (P_IN - P_Return) i (Intensification)
• Mounting: Inline tube

HC2P: 10 different intensification factors

• P_IN: 0.4 bar vacuum to 2 bar in suction line (inlet pressure)
• P_H: 800 bar maximum (outlet pressure)
• P_OUTLET P_H = (P_IN - P_Return) i (intensification)
• Mounting: Inline tube
• Rotation speed: Minimum 1,200 min-1 / maximum 3,000 Min-1
• Starting torque: Maximum starting torque 0.14 Nm
• Power consumption: 87 W

Zero Point Mounting System 3000

Zero Point Clamping System Hilma 3000

HILMA WZ 8.18344 Roller Bars with Spring Pack for medium loads, for linear movement of dies

• Load-bearing capacity up to 66 kN/m, flexible roller spacing and orientation
• Any variable length in one-piece design up to 2900mm
• Suitable for T-slots with a size of 18, 22, 28 or 36 mm
• Any variable length and roller spacing can be produced to meet customers' requirements

HILMA WZ 6.2275 Clamping Nut, Mechanical with blind hole thread, without clamping force display

• T-slot DIN 650: 18 - 42 mm
• Clamping force: 60 - 200 kN
• Max. tightening torque: 25 - 90 Nm

HILMA WZ 5.2650 Swing Clamps electro-mechanical, with position monitoring

• Clamping force: 70 - 160 kN
• Max. static force: 110 - 300 kN
• Clamping speed: 3.8 - 4.1 mm/s
• Motor voltage: 400 V / 50 Hz
• Motor rating: 0.55 - 1.1 kW
• Clamping stroke: 11 - 12 mm
• Swing stroke: 8 - 13 mm

Hilma Automatic Rapid Clamping System suitable for various die sizes

HILMA WZ 2.1833 Swivel and Pull Clamps for presses and high-speed punching presses when the available space is limited

• Max. clamping force: 30.4 kN
• Clamping stroke: 30 mm
• Swing angle: 90°
• Max. flow rate 15 cm³/s