As a distributor for Worldwide brands such as Carr Lane, Bosch Rexroth and Enerpac, HYQUIP aim to showcase all prodcuts and ranges, including new products as soon as they hit the market. See below for the latest products from our manufacturers.
ROEMHELD WS 5.4501 - Workholding Systems MC-P, Clamping Against the Fixed Jaw
Max. clamping force:
ROEMHELD RHI-S026 Bore Clamps eccentric design, seat check + clamping and unclamping monitoring, for bore holes
ROEMHELD B1.829 Hinge Clamps with Flat Clamping Lever: with pneumatic position monitoring, single and double acting
When pressurising the hinge clamp, a piston moves upwards against the rear edge of the clamping lever and swivels the clamping lever to the clamping position. The piston force is deviated by 180 ° onto the workpiece. The clamping force depends on the operating pressure and the length of the clamping lever.
ROEMHELD B1.8268 Hinge Clamps 70 bar: with throttle valve, metallic wiper edge and optional position monitoring double acting
The hinge clamp is a double acting hydraulic cylinder with integrated clamping lever. When pressurising the element, the piston moves upwards and swivels the clamping lever over the hinges forwards and at the same time downwards onto the workpiece. The piston force is deviated by 180° and, depending on the lever length, the force is available as clamping force.
ROEMHELD B1.8271 Mini Compact Clamp: Cartridge type, clamping force 1.3 kN double acting, max. operating pressure 200 bar
The hydraulic mini compact clamp is a double acting pull-type cylinder where a part of the linear stroke is used to swing the clamping lever onto the workpiece. In order to minimise the dimensions, the usual flange for screw fixing is omitted.
ROEMHELD B1.8510 Swing Clamps with Sturdy Swing Mechanism: Top flange type, with optional position monitoring, double acting
The hydraulic swing clamp is a pull-type cylinder where a part of the total stroke is used to swing the piston. Due to the sturdy swing mechanism the angle position of the clamping arm remains the same after a slight collision with the workpiece during loading and unloading or during clamping. The angle position of the clamping arm is fixed with a dowel pin.
ROEMHELD B 1.9472 Threaded-Body Work Supports with metallic wiper edge and long shaft, single and double acting
OBSOLETE ITEM - CONTACT HYQUIP
The support plunger is hydraulically extended and retracted by means of a small single or double-acting cylinder. Contact to the workpiece is made by spring force. The pressure spring can be easily exchanged. The support plunger is additionally guided in the area of the shaft diameter and can therefore absorb side loads up to 300 N.
Block cylinders and mini slides with force/stroke measuring system
ROEMHELD Synchronous Flow Dividers, made to split the entering input flow into two equal output flows
ROEMHELD D8.751 Compact Intensifieirs that convert the hydraulic pressure input into a higher pressure output.
ROEMHELD D8.757 Hydraulic intensifiers convert a low input pressure into a higher output pressure according to the intensification ratio
An oscillating pump piston, that will be automatically reversed in the end positions by a hydraulically-operated valve, is installed in the intensifier. The ratio of the piston areas corresponds to the intensification ratio. For unhindered flow in the low-pressure range, the pump piston will be bypassed by means of a bypass-line. A pilot-controlled check valve shuts off the high pressure.
ROEMHELD WZ 2.2097 Clamping Bars double acting, with built-in pistons
